Set your dimensions
Editable sample, not physically tested. Stored dimensions are millimeters.
Floor dimensions are measured between score lines; wall height runs from floor score to top edge. Four corner tabs are glued inside the side walls.
Tray
Nominal inside: 90.00 × 60.00 × 20.00 mm
Complete dieline: 130.00 × 100.00 mm
A4: 210 × 297 mm · Four edge margins: 5 mm
Usable area: 200.00 × 287.00 mm
0°: fits · 90°: fits
This part fits at actual size.
Cut, score and assemble
Numbered schematic of the current geometry, not a finished-box photograph. Solid: cut; dashed: score; shaded 4: corner glue tabs.
Tray
- Keep floor 1 flat. Cut the outer contour and score every dashed line, including tab hinges.
- Raise walls 2 by 90°. Fold shaded tabs 4 inward by 90°.
- Apply adhesive to the outward-facing surface of tabs 4. Raise walls 3 outside the tabs and bond each tab to the inside face of wall 3. Hold square until dry.
Print at actual size
Choose Actual size / 100%, turn off Fit to page, and confirm paper and margins. Before cutting, measure the known floor width shown above and check the entire contour. PDF never tiles or shrinks. SVG width and height are millimeters: preserve these physical dimensions in your printing software.
Examples & questions
Load sample / reset loads editable software examples, not physically verified projects. Unit changes preserve physical size. Language changes retain this tool’s settings; another box style uses its own parameters.
No thickness or bend compensation is applied. Paper and glued tabs can reduce finished inside space below nominal score-to-score dimensions. Trial assemble before fitting another box. No glue-free, load capacity or food contact claims.
Real-phone file saving, measured printing and physical assembly remain to be confirmed.